Roll-Over Protective Structures (Rops) / Operator Protective Guards Of Top Guard Level I (Opg (Top Guard Level I)) - Kubota u25 Operator's Manual

10 CHECKS BEFORE START
BRoll-Over Protective Structures (ROPS) /
Operator Protective Guards of Top Guard
Level I (OPG (Top Guard Level I))
For your safety, ROPS / OPG (Top Guard Level I) with a
seat belt is installed with your machine. A ROPS / OPG
(Top Guard Level I) label is fastened to the ROPS / OPG
(Top Guard Level I). This label shows the serial No. of
ROPS / OPG (Top Guard Level I), gross weight, approval
and regulation No. and model No. of the machine.
(1) Bolt
(2) Spring washer
(3) Plain washer
(1) Bolt
(2) Spring washer
(3) Plain washer
ROPS
MODEL No.
U25 CANOPY RFP 2820
To avoid personal injury or death:
A Do not modify a ROPS / OPG (Top Guard Level
I) in any way. Welding, grinding, bending,
drilling or cutting any portion of the ROPS /
OPG (Top Guard Level I) may weaken the
structure. Do not repair a damaged ROPS /
OPG (Top Guard Level I). A damaged ROPS /
OPG (Top Guard Level I) structure must be
replaced, not repaired or revised. If any
structural member of the ROPS / OPG (Top
Guard Level I) is damaged, replace the entire
structure at your local KUBOTA dealer. Check
the seat belt daily and replace it if damaged or
frayed.
A Do not remove the ROPS / OPG (Top Guard
Level I) except for service. Install the ROPS /
OPG (Top Guard Level I) correctly before you
operate the machine again.
QTY. Grade
Bolt M14 2 9T
Bolt M16 2 9T
Nut M14 4 6T
Nut M16 4 6T
A Do not install any attachments that will cause
the total gross weight of the machine to exceed
the weight shown in the "FOR MAXIMUM
GROSS MACHINE WEIGHT" space on the
ROPS / OPG (Top Guard Level I) label.
MAX. GROSS
ROPS
MACHINE
PARTS No.
MASS
2820 kg
RB419-4531
(6217 lbs)
Tightening Torque
124 to 147 N-m
(12.6 to 15.0 kgf-m)
196 to 226 N-m
(20.0 to 23.0 kgf-m)
108 to 126 N-m
(11.0 to 12.8 kgf-m)
167 to 191 N-m
(17.0 to 19.5 kgf-m)