Parking On A Slope; Important Information On Excavator Operation - Kubota u25 Operator's Manual

PARKING ON A SLOPE

To avoid personal injury or death:
A When the excavator
unattended on a slope, be sure to put the
bucket on the ground and place all control
levers in neutral position, then brace the tracks
with chocks.
(1) Chock
is parked or left
EXCAVATOR OPERATION
IMPORTANT INFORMATION ON
EXCAVATOR OPERATION
A Do not try to crush concrete or boulders using side
swings with the bucket. Also avoid using side sweeps
of the bucket to move earth piles.
A Under all circumstances
operations:
A Excavation using the gravitational impact of the
machine.
A Compacting of gravel or soil using the dropping
action of the bucket.
A Excavation using the traveling power of the
machine.
A Do not try to drop or shake off soil adhering to the
bucket in the manner given in the points below. This
can cause damage to the machine.
Adhering soil can be shaken off when the bucket is
being emptied by moving the bucket out to the
maximum stroke of the cylinder. Should this not
suffice, swing out the arm as far as possible and
operate the bucket back and forth.
A Do not hit the dozer with the boom cylinder!
Make sure that the boom cylinder does not hit the
dozer when doing deep excavation. If necessary
swing around so that the dozer is in the back of the
machine.
A Pay attention when pulling in the bucket!
When pulling in the
transportation) avoid hitting the dozer.
A Avoid collisions!
When moving the excavator, pay attention that the
dozer does not collide with obstructions such as
boulders, etc.
Such collisions shorten the life of the dozer and the
cylinder substantially.
A Support the machine correctly!
When stabilizing the machine with the dozer, lower the
dozer to engage the full width on the ground.
A If the water or mud level reaches higher than the top of
the tracks, the swivel bearing, swivel motor gear and
ring gear may be exposed to mud, water and other
foreign objects.
The excavator must be properly pressure washed
after each use.
A Thoroughly clean the area around the swivel
bearing, swivel motor gear and ring gear to remove
foreign objects.
A Inspect the swivel motor oil sump (if equipped) for
water contamination. If water is present, refer to
operator's manual for lubricant replacement
procedure.
A Refer to operator's manual for proper swivel
bearing, swivel motor gear and ring gear
lubrication procedures.
A Reinstall any protective covering if removed
earlier.
29
avoid the following
bucket (for driving or