Table of Contents
Advertisement
Precautions for Use
Precautions for installation
Install the device in a position where it will not block the front view of the driver (position where
z
hidden by the rear-view mirror).
Install the device so that it is within the wiping range of the wiper.
z
Install the device in a position where it will not interfere with the movement of the rear-view
z
mirror.
Take care not to install the device over the vehicle inspection sticker or other sticker.
z
Take care not to install the device where it will interfere with driving or airbag operation.
z
When installing the device in a vehicle equipped with a driving support system, check the
z
instruction manual of the vehicle and then select an installation location that will not interfere
with the driving support system.
If the device is installed incorrectly, event recording or parked recording may not work correctly.
z
Refer to "How to Install" for the loosening of fixing knob, installation orientation, installation angle,
and other information and then install the device correctly.
Do not install the device near a digital terrestrial television antenna or an electrical component.
z
Doing so may reduce television receiver sensitivity or cause flickering and noise.
Use a commercially available cleaning cloth or the like to wipe off all dirt and grease on the
z
mounting surface and then fix the mount base in place. If the device is re-affixed or mounted
using, for example, general-purpose double-sided tape, the adhesion strength may weaken and
cause the device to fall.
After mounting the device, leave it for 24 hours before use to enable the mounting strength of
z
the mount bracket to improve. Failing to do so may result in the adhesion of the mount bracket
becoming weak and the device falling.
Fix the cord in place with tape or the like so that it does not interfere with driving.
z
10
(➜ P. 12)
Precautions for use
Do not block the camera lens, get dirt on it, or place a reflective object near it.
z
When LED traffic lights are recorded, video in which they appear to be flickering or flashing
z
may be recorded. JVC KENWOOD assumes no responsibility with regard to the distinguishing
or recording of traffic lights.
If coating is used on the windshield of the vehicle, recording quality may be affected.
z
There is no guarantee that the device can record video in all conditions.
z
Cleaning the device
When the device is dirty, wipe it with a dry silicone cloth or other soft cloth. If the device is very
z
dirty, remove the dirt with a cloth with neutral cleaner on it then wipe off the cleaner. Wiping
the device with a hard cloth or using a volatile substance such as thinner or alcohol may cause
scratches, deformation, deterioration or other damage.
When the lens is dirty, gently wipe it with a soft cloth dampened with water. Rubbing the lens
z
strongly with a dry cloth may cause scratches.
If you notice a problem with the device
If you notice a problem with the device, first refer to "Troubleshooting"
there is a way to resolve the problem.
If the device does not return to normal, turn off the power of the device and then contact your
dealer or nearest JVC KENWOOD service center.
➜ P.
41and check whether
11
Hide quick links:
Advertisement
Table of Contents
