Download  Print this page

Kenwood DRV-830 Instruction Manual page 18

Gps integrated dashboard camera
Hide thumbs

Advertisement

Configuring the Settings
Driving support settings
Forward collision warning
ON/OFF*
This function detects the distance between you and the vehicle in front, and
sounds a warning if the distance is not safe in order to prevent a collision with
the vehicle in front. This functions at speeds of approximately 30 km/h and higher.
Lane departure warning
ON/OFF*
This function detects the lane in which you are driving and sounds a warning if you
veer out of that lane. This functions at speeds of approximately 60 km/h and higher.
Departure delay warning
ON/OFF*
This function sounds a warning if, while you are stopped, the vehicle in front of
you has taken off and your departure is too slow. With this function, a warning is
also sounded if you are backing up.
Detection range
Adjust the horizon, position of the front tip of the engine hood, etc., before using
the driving support functions.
Mounting height
1.2 m*/1.35 m/2 m
Set the height from the road surface to the position at which the camera is
mounted.
(➜ P. 17)
System settings
Date/time
Automatic*/Manual
Set whether to record the date and time automatically or manually.
You must set the "Time Zone"
Daylight saving time
OFF*/+1 hr./+30 min
Notification volume
The volume of the notification sound can be set in 6 steps (mute to maximum).
The notification sound is the sound issued as guidance during event recording,
when operating buttons, etc.
Playback volume
Set the volume of the sound when playing recorded files in 6 steps (mute to
maximum).
Monitor
Time settings 10 sec.*/1 min./3 min.
Set the time after which the monitor screen switches to the power-saving mode
during recording.
Operation settings
Always on*/OFF/Dim
Set the monitor screen's power-saving operation during recording. When the
MENU/OK button is pressed, the power-saving operation is temporarily canceled.
Mounting support tool
Level
Use this to check whether the camera is level.
Satellite reception level
This displays the positioning satellite reception strength screen.
Select units
km/h/mph*
Switch to kilometer or mile display.
Factory reset
Restores the settings to the values set upon purchase.
When executed, the power turns off then back on and the setup screen appears.
Follow the instructions on the screen to configure the settings.
Setup
Configure the settings related to installation of the camera in a specific order.
Update system
Update the camera's firmware.
System version
Display the camera's firmware version.
34
* Factory default settings
(➜ P. 17)
(➜ P. 36)
Set daylight saving time.
About updating the system
This function updates the camera's system firmware. For information and instructions on
updating, see the Kenwood website. http://www.kenwood.com/cs/ce/
SD card menu
SD card information (Slot 1)
Display the information screen for the SD card in slot 1.
SD card information (Slot 2)
Display the information screen for the SD card in slot 2.
Format SD card (Slot 1)
Formats the SD card in slot 1, deleting all the files on the card.
Format SD card (Slot 2)
Formats the SD card in slot 2, deleting all the files on the card.
35

Advertisement

Table of Contents
loading

  Related Manuals for Kenwood DRV-830