Table of Contents
Advertisement
2. Select the [Stabilization] menu from the [System] menu.
The [Stabilization] menu appears.
3. Set [Stabilization] to [On] to enable the stabilization mode.
Turn this function on when seas are rough, to get stable pictures regardless of sea
conditions. When heaving stabilization is turned on, the symbol (
the "Advance" header on the screen.
4. Select the model of Satellite Compass
When you select other than 'manual', go to step 6.
5. Set the delay time between 0 and 1000 ms.
6. Set the antenna position for the Satellite Compass
[Height]
[Height]
Transducer
• TD fore-aft: Distance (m) from antenna to transducer on the fore-aft line. Enter
a positive value for a fore-side transducer, a negative value for an aft-side trans-
ducer. (-100.0 to +100.0m)
• TD port-stbd: Distance (m) from antenna to transducer on the port-stbd line. En-
ter a positive value for starboard-side transducer, a negative value for a port-
side transducer. (-100.0 to +100.0m)
• ANT TD height: Vertical distance (m) between the antenna and the transducer.
(0.0m to 110.0m)
7. Select the [OK] to close the menu.
Note: For the heaving feature, set the SC-30/50/110 Satellite Compass
follows. Refer to respective operator's manual for setting details.
Feature
SC-50/110 (Data out setting)
Sentence
ATT, HVE
Baud rate
38400 bps
Cycle
25 ms
xx.xx
™
from the list on menu.
SC-30/50/110
Antenna
Transducer
Transducer
FORE (+) / AFT (-)
FORE (+) / AFT (-)
SC-30 (IF-NMEASC setting)
ATT, HVE
38400 bps
25 ms
3. INITIAL SETTINGS
) appears at
™
.
STBD(+)
STBD(+)
PORT(-)
PORT(-)
™
output as
3-15
Advertisement
Table of Contents
