Table of Contents
Advertisement
Item
Gain stabilization (LF/HF)
TD fore-aft/port-stbd
ANT TD height
[Height]
[Height]
Transducer
4. Select [OK] to close the menu.
External Echo Sounder mode is 'On'
1. Select the [Display] icon (
ternal Sounder] icon (
The external echo picture is displayed on sub monitor.
2. Move the cursor onto the sub monitor and right-click on the screen.
The setting menu for external echo sounder appears.
3. Select [Service] of the setting menu and press and hold [OK] for approximately ten
seconds.
The expanded menu appears under the service column.
4. Select the [Calibration] menu from the [System] menu.
The [Calibration] menu appears.
5. Set the calibration parameters referring to the table below:
Item
Zero line rejection
Zero line area
Draft
Meaning
Set the antenna position for the
Satellite Compass
Distance (m) from antenna to
transducer on the fore-aft/port-stbd
line. Enter a positive value for a
fore-side transducer.
Vertical distance (m) between the
antenna and the transducer. Enter
a positive value for starboard-side
transducer.
SC-30/50/110
Antenna
Transducer
Transducer
FORE (+) / AFT (-)
FORE (+) / AFT (-)
) from the InstantAccess bar
) from the expanded menu bar.
Meaning
Turn the zero line (transmission line) on
or off.
Adjusts the transmission line.
The default depth display shows the dis-
tance from the transducer.
3. INITIAL SETTINGS
Setting values
-50 to +50
™
.
-100.0 to +100.0 m
0.0 to 100.0 m
STBD(+)
STBD(+)
PORT(-)
PORT(-)
™
, and select the [Ex-
Setting values
Off/ On
1.4 to 3.0 m
-9.0 to +30.4 m
3-13
Advertisement
Table of Contents
