Table of Contents
Advertisement
1. MOUNTING
Surface mounting
1. Drill four holes ( 4) on the table re-
ferring to the outline drawing at the
back of this manual.
2. Secure the trackball control unit with
four screws (M3, local supply) from
the underside of the table.
The length of screws should be de-
termined depending on the thick-
ness of panel. Refer to the outline
drawing at the back of this manual.
1.4.2
How to mount the unit in a console panel
Use the optional flush mount kit OP14-70 to install the unit in a console.
Name
SEMS B screw
FM1 assy.
FM2 assy.
FM1 fixture
Note: Do not mount the trackball control unit on a inclined surface, as drainage may
be prevented.
1. Prepare a cutout in the in-
stallation location. Refer to
the outline drawing at the
back of this manual for the
cutout dimensions.
2. Set the unit to the cutout.
3. Attach the mounting plate
to the unit with four screws
(M3x8, supplied) from rear
side.
4. Screw the wing bolts and
the wing nuts so that the
protectors for the screws
move to the flush mount
assembly.
5. Fasten each wing bolt and then fasten each wing nut.
1-6
Flush mount kit OP14-70
Type
Code No.
M3 x 8
000-162-649-10
OP14-70-1
001-133-860
OP14-70-2
001-133-870
14-078-2301-1
100-364-711-10
M3x8 (4 pcs.)
FM2 assy.
180
M3
φ4
114
QTY
Remark
4
2
w/ wing bolt/nut
2
w/ wing bolt/nut
2
Spare
FM1 assy.
Wing bolt
Wing nut
40
Advertisement
Table of Contents
