Table of Contents
Advertisement
2. WIRING
1
Expose inner vinyl sheath.
4
approx. 9 mm
Fold back drain wire and
cut it, leaving 9 mm.
7
Using special crimping tool
MPT5-8AS (PANDUIT CORP.),
crimp the modular plug.
Finally check the plug visually.
2.2.4
Ethernet HUB and USB Device Server
The optional USB device server UDS-001 enables the extension of the trackball con-
trol unit cable. The optional HUB-101 Ethernet HUB is required to connect the UDS-
001. The Ethernet HUB also allows connection to external network fish finders. Refer
to the interconnection diagram at the end of this manual to connect the units.
When connecting the trackball control unit TCU-001, the UDS-001 DIP switches must
be returned to the default settings, as follows:
SW No.
SW1
SW2
SW3
2-12
2
25 mm
Remove the outer sheath by
approx 25 mm. Be careful
not to damage inner shield
and cores.
5
approx. 11 mm
Straighten and flatten the
core in order and cut them,
leaving 11 mm.
Modular plug
1
8
Settings (default)
OFF
ON
OFF
OFF
3
approx. 9 mm
Fold back the shield, wrap it
onto the outer sheath and
cut it, leaving 9 mm.
6
Drain wire
Insert the cable into the modular
plug so that the folded part of
the shield enters into the plug
housing. The drain wire should
be located on the tab side of
the jack.
[Cross cable]
1 WHT/GRN
WHT/ORG 1
2
GRN
WHT/GRN 3
3 WHT/ORG
4
BLU
5 WHT/BLU
WHT/BLU 5
6
ORG
WHT/BRN 7
7 WHT/BRN
8
BRN
ORG 2
BLU 4
GRN 6
BRN 8
Advertisement
Table of Contents
