Table of Contents
Advertisement
6.3 IPOE-171-60W and IPOE-171S Installation
1. Adjust proper DC power output and connect wire from "Power
Output" of IPOE-171S to remote device.
2. Connect the power ranging from 48V DC to 56V DC to the 6-pin
terminal block of the IPOE-171-60W. The power LED will be steadily
on.
3. Connect a standard Ethernet cable from an Ethernet switch or PC
workstation to the "Ethernet" port of the IPOE-171-60W.
4. Connect a standard Ethernet cable from "Ethernet+DC" port of the
IPOE-171-60W to "PoE In" port of the IPOE-171S. The "PWR" and
"60W" LEDs of the IPOE-171S and the "PoE-in-Use" of the IPOE-
171-60W will light up continuously.
5. Connect a standard Ethernet cable from the "Ethernet" port of the
IPOE-171S to the remote Ethernet device.
6. The remote device will be turned on and connected.
DC Input
Power
DC
Supply
Power
Data
Industrial
Switch
IPOE-171 Series
1000BASE-T UTP
1000BASE-T UTP with PoE
PoE
Power Line (DC)
DC
Figure 15: Connected Architecture of IPOE-171-60W and IPOE-171S
Please ensure the IPOE-171S output voltage is correct
before applying power to remote device.
Note
22
100 meters
75 ℃
-40 ℃
Industrial 802.3bt
PoE Splitter
Power
Data
PoE
Digital Signage
Data
DC
Power
12V/24V DC Output
Advertisement
Table of Contents
