Wiring The Power Inputs - Planet IPOE-171-60W User Manual

4.4 Wiring the Power Inputs

The 6-contact terminal block connector on the top panel of the IPOE-
171 series is used for two DC redundant power inputs. Please follow
the steps below to insert the power wire.
Step 1: Insert Positive / Negative DC power wires into Contacts 1 and
2 for POWER 1, or 5 and 6 for POWER 2.
Step 2: Tighten the wire-clamp screws for preventing the wires from
loosening.
Figure 7: PWR1 & PWR2 Pins of Terminal Block.
1. The wire gauge for the terminal block should be in the
range between 12 ~ 24 AWG.
2. As the DC input connector of the IPOE-171 series is
polarity protected, connecting Positive / Negative DC
Note
power wires to the wrong pins will not damage the
unit.
1 2 3 4 5 6
V1+ V1- V2+ V2-
PWR1 Fault PWR2
Figure 6: Power input pins.
1 2 3
Power 1 Fault
+ -
Input
DC 48~56V
4 5 6
Power 2
+ -
15