Description Of Lcd Annunciators; Inserting & Removing The Rubber Boot/Stand - LaMotte DO 6 PLUS Instructions Manual

2.2

Description of LCD Annunciators

The meter has a large custom LCD that consists of 4-digit segments plus
annunciators for percentage saturation (%), concentration (mg/L or ppm)
and Temperature in degrees Celsius (T).
Other annunciators include "A" (when the ATC function is activated),
"CAL" (when meter is in calibration mode) and low battery condition.
Calibration Mode
Annunciator
CAL
14-segment Liquid Crystal Display
2.3 Inserting & Removing the Rubber Boot/Stand
1. To remove the meter from the rubber boot, push out the bottom
edge of the meter until it is completely out of the boot. Ensure
that the probe cables are not connected. See Figure 1.
2. To insert the meter into the rubber boot, slide in the top of the
meter before pushing the bottom edge of the meter down to set it
into position. Lift up the stand at the back of the meter for bench
top applications. See Figure 2.
Figure 1
Low Battery annunciator
Temperature Mode
TA
7
A T C annunciator
mg/l milligram per litre
(Concentration Mode)
ppm
parts per million
%
Percentage
(Percentage Saturation
Mode)
Figure 2