Table of Contents
Advertisement
2.2 Description of LCD Annunciators
The large custom LCD consists of 3½-digit segments which uses
annunciators for pH, mV or oC (Temperature). No annunciator is shown
in Ion mode. Other annunciators include "HO" (when HOLD function is
activated) and "LO" (low battery condition).
2.3 Inserting & Removing the Rubber Boot/Stand
1. To remove the meter from the rubber boot, push out the bottom
edge of the meter until it is completely out of the boot. Ensure
that the probe cables are not connected. See Figure 1.
2. To insert the meter into the rubber boot, slide in the top of the
meter before pushing the bottom edge of the meter down to set it
into position. Lift up the stand at the back of the meter for bench
top applications. Figure 2.
Figure 1
Figure 2
7
Advertisement
Table of Contents
