Holding A Reading; Setup - LaMotte DO 6 PLUS Instructions Manual

4.4

Holding a Reading

To hold the displayed reading momentarily, press HOLD/ENTER
during any measurement. The %, mg/L, ppm or T annunciator will blink,
indicating that the value is being held.
Press HOLD/ENTER again to deactivate the HOLD function. The meter
will revert to the current active measurement and the annunciator will
stop blinking.
If the auto-off feature is activated, the meter will turn off automatically
after 20 minutes of non use The HOLD value is not retained when the
meter is shut off automatically or manually.

5. SETUP

There are two setup menus. One menu is derived from the % saturation
and temperature modes; the other menu is derived from the mg/L (or
ppm) concentration mode.
1. Press MODE to display % saturation or temperature. Press ON/
OFF to power off.
OR
Press MODE to display mg/L (or ppm). Press ON/OFF to
power off.
2. With the meter off, keep the MODE key pressed. Press and
release ON/OFF, then release MODE. The meter should display
"SEt.P" after ON/OFF is released and "COF.1" after MODE is
released.
Press CAL one or more times as needed during setup mode to exit and
return to measurement mode at any time.
A
%
Annunciator Blinks when
meter is in "HOLD" mode
19