Table of Contents
Advertisement
6.4.1
Linking actuator and sensor
Fig. 20:
Linking actuator and sensor
1. On the working area select the sensor [1] that is to be linked with the actuator.
2. Select the actuator [2] that is to be served by the sensor.
3. Press the tick at the bottom right to take over the entries.
A blue connecting line indicates the link between the two devices. The configuration is now
transmitted automatically to the devices. The transmission can, depending on the number of
affected devices, take a number of seconds. During the transmission a progress bar is
displayed around the devices affected.
Technical Reference Manual 2CKA001473B9194
Commissioning
│29
Advertisement
Table of Contents
