Table of Contents
Advertisement
6
Commissioning
Commissioning of the device is always carried out via the Web-based surface of the System
Access Point. It is assumed that the basic commissioning steps of the overall system have
already been carried out. Knowledge about the Web-based commissioning software of the
System Access Point is assumed.
The System Access Point establishes the connection between the free@home participants and
the smartphone, tablet or PC. The System Access Point is used to identify and program the
participants during commissioning.
When energized, a device that has not been programmed is in programming mode for 30
minutes and can be logged into the system. Programmed devices share information about their
type and supported functions with the System Access Point.
During initial commissioning all devices are given a universal name (Sensor/switch actuator
1/1gang, etc.). The installer must change this name within the commissioning process to a
name practical and specific for the system (in case of an actuator, e.g. to "Living room ceiling
light").
The devices must be parameterised for the use of additional functions.
NOTE
General information about commissioning and parameterization is available in
the technical reference manual and the online Help of the System Access Point.
Technical Reference Manual 2CKA001473B9194
Commissioning
│17
Advertisement
Table of Contents
