Pico Wireless Control Setup; Associating With A Grafik Eye Qs Wireless Control Unit - Lutron Electronics GRAFIK Eye QS Quick Installation And Operation Manual

Pico Wireless Control Setup

Associating the Pico wireless control with a GRAFIK Eye QS Wireless
control unit (for wireless enabled GRAFIK Eye QS control units only)
1. Make sure the wireless mode of the GRAFIK Eye QS
Pico
control unit is "Enabled".
Change Type?
2. On the Pico wireless control, press and hold the top (on)
and bottom (off) buttons for 3 seconds. The info screen
Press OK
on the GRAFIK Eye QS control unit will display the Pico
options. Press the OK button on the GRAFIK Eye QS
Change Type? control unit to select the desired operation type for the
Pico.
3. Assign Pico wireless control.
Zone
a. To assign the Pico wireless control as a zone controller,
use the Master buttons to select "Zone" and press
OR
the OK button to accept. Use the zone raise/lower
Change Type?
buttons for a zone to select a desired preset level,
and then press the zone raise and lower buttons
simultaneously for 1 second (until the zone LEDs flash
Scene
at the programmed preset level). Repeat for all zones
you wish to control with the Pico wireless control.
OR
b. To assign the Pico wireless control as a scene
controller, use the Master buttons to select "Scene"
Saved
and press the OK button to accept. Press and hold the
top scene button on the GRAFIK Eye QS control unit
for 3 seconds (until the scene LEDs flash).
4. On the Pico wireless control, press and hold the top and bottom buttons
for 3 seconds until the LEDs on the GRAFIK Eye QS control unit stop
flashing.
Note: The wireless signal has a range of 9 m through standard
construction or 18 m line-of-sight.
For additional information, see the complete installation and operation guide at www.lutron.com/qs
GRAFIK Eye QS with DALI
16
9-16
1-8
OK
1 9 2 10 3 11 4
Wireless Control
Control Unit Quick Installation and Operation Guide
®
Master buttons
OK button
Press and hold the
top scene button for
3 seconds to assign
Pico as a scene
controller
12 5 13 6
Zone raise
Zone lower
Zone LEDs
Pico
Top/On button
Bottom/Off button
20