Wireless Functions - Lutron Electronics GRAFIK Eye QS Quick Installation And Operation Manual

Troubleshooting: Wireless Functions (for wireless-enabled units only)
Symptom
Cannot associate a wireless
device to a unit
Associated wireless devices
do not control unit
Wireless devices operate
incorrectly
Wireless devices selectively
operate
Info screen often prompts
for wireless device
association
Possible Causes
Unit does not support wireless functionality
Unit in incorrect wireless mode
Maximum number of devices have been
associated with unit
Wireless device is out of range
Wireless device has been unassigned from unit Reassign wireless device to unit
Devices are not receiving power
Unit in incorrect wireless mode
Multiple devices are associated to the unit with
contrasting settings
Wireless device is out of range
Radio Powr Savr daylight sensors not in
calibration mode
System is not configured correctly
Intended settings were not saved
Wireless devices not located correctly
Unit wireless mode set to "Enabled"
and nearby wireless systems are being
programmed
For additional information, see the complete installation and operation guide at www.lutron.com/qs
GRAFIK Eye QS with DALI
Solution
Verify the unit says "GRAFIK Eye QS Wireless" on the front label
Change wireless mode to "Enabled"
Remove devices or associate with a different unit
Verify wireless device is in range: 9 m through standard construction,
18 m line-of-sight)
Check wireless device's battery/power wiring
Change to correct wireless mode ("Ignore Programming" or "Enabled")
Verify the settings of wireless devices are consistent
Verify wireless device is in range: 9 m through standard construction,
18 m line-of-sight)
Follow instructions to calibrate daylight sensors
Make sure wireless device settings are programmed as desired
Reprogram wireless device settings
Follow instructions for each device to verify it is located for ideal
performance
Change wireless mode to "Ignore Programming"
Control Unit Quick Installation and Operation Guide
®
22