Zone Setup; Assigning Load Types; Assigning Non-Dim Load Type - Lutron Electronics GRAFIK Eye QS Quick Installation And Operation Manual

Zone Setup

Assigning Load Types

Load types supported by the GRAFIK
Eye QS with DALI :
®
• Digital load
• DMX
• RGB/CMY DMX
• Non-dim digital
Note: For all DMX or RGB/CMY DMX lighting, an external
DMX interface (such as the QSE-CI-DMX) must be
used with the control unit.
1. Enter programming mode.
Main Menu
2. Use the Master buttons to
CCI Setup
highlight "Zone setup" and press
the OK button to accept.
Zone Setup
3. Use the Master buttons to
highlight "Load type". Press the
Zone Setup
OK button to accept.
4. Use the zone raise/lower buttons
Load Type
to choose the load type for that
Non-Dim Load Type
zone. See the list above for
supported load types. Press the
OK button to accept.
Load Type
5. The info screen will confirm that
Set Zones
your load type has been saved.
6. Exit programming mode.
Saved
16
9-16
1-8
OK

Assigning Non-Dim Load Type

Zones assigned to non-dim loads have five available configurations:
• LOLO: Last On, Last Off
• LOFO: Last On, First Off
• FOFO: First On, First Off
• FOLO: First On, Last Off
• 60/40: On at 60%, Off at 40%
Scenes made up of both dim and non-dim load types will toggle the
non-dim loads before the dim loads in a "First" on/off configuration,
and after the dim loads in a "Last" on/off configuration.
Main Menu
CCI Setup
Zone Setup
Zone Setup
Load Type
Non-Dim Load Type
Load Type
For additional information, see the complete installation and operation guide at www.lutron.com/qs
GRAFIK Eye QS with DALI
1 9
Master buttons
OK button
1. Enter programming mode.
2. Use the Master buttons to highlight "Zone
setup" and then press the OK button to
accept.
3. Use the Master buttons to highlight "Non-Dim
Load type". Press the OK button to accept.
4. Use the zone raise/lower buttons to choose
the non-dim load type for that zone (zones not
programmed as non-dim will be displayed as
Unaffected). Press the OK button to accept.
5. The info screen will confirm that your load type
has been saved.
Set Zones 6. Exit programming mode.
Saved
Control Unit Quick Installation and Operation Guide
®
Use the
2 10 3 11 4 12 5 13 6
zone
raise/lower
buttons to
choose the
load type for
that zone
12