Canon KJ10ex4.5B Operation Manual page 56

5 OPERATION
Framing Preset [Zoom]/[Zoom, Focus] Setting
Concerning the illustrations
NOTE
The illustrations show the switches with the functions below allocated to them. Bear in mind, however,
that if these functions have been allocated to other switches, there will be a discrepancy between what is
shown in the illustrations and the actual statuses of the switches.
1）"Shtl" function------------This is allocated to the AUX1 switch (factory setting).
2）"FRM1" function---------This is allocated to the AUX2 switch (factory setting).
1. How to store the Framing memory position
Zoom Rocker Seesaw
"FRM1" Button
Memo Button
2. How to move to the framing memory position
Zoom Rocker Seesaw
"FRM1" Button
3. How to cancel movement to the framing memory position or switch to other zoom operations
During movement to the framing memory position, the movement can be canceled and/or switched to other
zoom operation by any of the following operations.
[Zoom Framing Preset]
• Pressing the "FRM1" button again.
• Zoom operation with the zoom rocker seesaw can immediately take over.
• Zoom operation with the "Shtl" button can immediately take over.
[Zoom, Focus Framing Preset]
• While is RET switch is held down, the on-air picture (returned picture) can be seen in the viewfinder.
Zoom (and focus) to the position that you want to store,
while holding this zoom (and zoom focus) position, press
the "FRM1" button while holding down the Memo button.
This stores the framing memory position.
Once the "FRM1" button is pressed, the zoom starts
to move toward the framing memory position at the
"Shtl" Button
preset speed. When the zoom reaches to the framing
memory position, it stops and stays there.
E22
NOTE
This framing memory position is different from the
shuttle memory position (Refer to "5-1-4. Suttle-
Shot Function").
The stored zoom position remains in the memory,
even after the power is turned off.
NOTE
It is not necessary to hold down the "FRM1" button,
until the zoom reaches to the framing memory
position, as for the Shtl button. (refer to "5-1-4.
Shuttle-Shot Function") Just simply press the
"FRM1" button.
LENSES