Canon KJ10ex4.5B Operation Manual page 55

LENSES
5-1-6. Framing Preset
There are two framing preset types based on how the settings are combined.
■ Framing Preset［Zoom］
This enables a predetermined picture angle and movement speed (zoom speed) to be reproduced
"
PRE" is the factory setting. If the
easily.
display.
■ Framiing Preset［Zoom, Focus］-------------------------------"A" type only
This enables the movement speed (focus speed, zoom speed) to a predetermined focus and picture
angle to be reproduced easily. It must be set on the information display.
Refer to the table below to perform the settings, since the settings using the information display is
varied according to the operation to be performed.
Reference:Table of setting combinations
Frame preset type
Zoom
1.
Zoom, focus
2.
1 : Concerning the zoom/focus ON/OFF setting
*
For the procedure to be following for performing the settings on the information display, refer to the Information Display
Manual.
2 : The zoom and focus are controlled in such a way that they start and stop simultaneously
*
NOTE
Up to two framing presets, Frame1 and Frame2, can be stored in the memory. Only Frame1 is described
in the description given on the following pages. Frame1 is indicated as "FRM1".
● How to set the zoom speed to the framing memory position
Preset
Frame1:
PRE
Frame2: PRE
ZSpeed: 800
"
FAST" setting is used, it must be set on the information
Zoom/focus *1
ON/OFF setting
Zoom Focus
ON OFF
ON ON
On the information display, select "PRE" or "FAST" as the "FRM1"
speed setting.
・ "PRE"------------For the preset speed setting （preset speed）
・ "FAST"-----------For the maximum speed setting （fast speed）
E21
Movement speed setting
"PRE"
(speed can be set)
The zoom moves at the preset speed.
*2
The zoom and focus move at the
preset speeds.
5 OPERATION
"FAST"
(maximum speed)
The zoom moves at the maximum speed.
The zoom and focus move at the
maximum speed.