Canon KJ10ex4.5B Operation Manual page 42

2 NOMENCLATURE
15
16
17
※ AUX1
Function can be allocated.
See E26 for details.
Information Display
Display Switch
Push this to show the display. When it is pushed once, the
display appears, when it is pushed again,the diplay is turned off.
DISPLAY
How to Operate the Control Key
Name
Set key
Arrow key
(Ex. Right key)
14
18
AUX1
Display
This appears when the DISPLAY switch is pushed.
If two or more minutes are allowed to elapse without any operation being performed,
the display turns off automatically.
Operation
Push
This key is pushed when {
display or when a selection is to be entered.
PUSH
Move right The operation of right key takes effect when {
appeared on the screen display.
( , ,
⑭ Zoom Focus Operation Change-over Knob
Use this knob to change from manual to servo zoom and
focus operation or vice versa.
[Zoom operation change-over knob only for "R" type.]
⑮ Hood Lock Knob
Loosen or tighten this knob to remove or fix the lens hood
on the lens.
⑯ Connector for Remote Zoom Control (8-pin)
Zooming is performed by remote control when this
connector is used to connect the unit to an optional control
unit for zoom operations.
Normally, this connector is covered with a cap.
⑰ Virtual & Zoom Remote/Focus Remote
Connectors (20-pin)
19
NOTE) Virtual output port is Connector ★ only.
Use these connectors to connect the control accessory
(equipped with a 20 pin connector) for zooming or focusing.
Connector ★ is also used to connect to the interface of
such as virtual system. It can output each positioning signal
of zoom, focus, and iris.
⑱ VTR Switch
Use this switch to start or stop the VTR.
⑲ Max. Zoom Speed Volume
The maximum zoom speed by zoom rocker seesaw can
be adjusted.
Digital Function Selector
(hereafter Control key or key )
This key is used to perform all the setting operations on the display.
Detailed description
} has appeared on the screen
, for up,down,right,left)
E8
LENSES
} has