Assembly:; Armrest (Fig. 7.2); Anti-Tip Wheels (Fig.7.3); Kerb Climber (Fig. 7.4) - Sunrise Medical Quickie Q100 R General Manual

Powered wheelchair
Hide thumbs Also See for Quickie Q100 R:
Table of Contents

Advertisement

7.0 Assembly:

7.1. Footrest (Fig. 7.0-7.1):
The Q100R.Q200R is supplied with two models of Swing
away footrest.
The footrests can be swung away by pulling the release
lever back towards the seat and pushing the hanger
outwards. To remove the footrest, activate the release
lever, rotate the footrest approximately 90° outwards and
then pull it out upwards. To refit the footrest follow the
reverse procedure and the lock engages automatically
when swung inward.
Fig. 7.0.1
Q100R

7.2. Armrest (Fig. 7.2):

Slide the armrest tube into the receiver of the wheelchair
and turn the lever to the right to secure it. If you require a
different individually fixed armrest height, you can set this
using the adjusting screw on the connecting tube.
Fig. 7.2

7.3. Anti-tip wheels (Fig.7.3):

These are mounted when the wheelchair leaves the
factory. The anti-tip wheel tube is welded to the main
chassis of the wheelchair frame.
Note: Anti-tips wheels may interfere with kerbs when
mounting or dismounting. Follow the instructions in
sections 6.9 & 6.10.
Never use the wheelchair without the anti-tip wheels fitted.
Fig. 7.0.2
Q200R

7.4. Kerb climber (Fig. 7.4):

Fig. 7.1
• The Q100R and Q200R are available with a kerb
• Fitting the kerb climber
• Remove the plastic cover at the front of the wheelchair
• Remove the two thin push out pieces from the plastic
• Mount the two side plates of the kerb climber through the
• Reassemble the plastic front cover – carefully guiding
• Mount the kerb climbing wheel through the provided
• Check assembly is fully tightened before use.
WARNING!
climber option, this can be fitted by your powerwheel
chair supplier.
by removing the 4 mounting screws.
cover.
provided holes of the front tube and tighten to 20-25Nm.
this over the two side plates of the kerb climber. Replace
the 4 screws and tighten to 1-2Nm.
hole and tighten assembly to 10-15Nm.
Fig. 7.3
Fig. 7.4
23
Rev. A Q100R Q200R

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Quickie q200 r

Table of Contents