12.0 Adjustments:
12.1 Adjustment of the footrest (Fig. 12.1.1 & 12.1.2):
To adjust the height of a footrest:
Depending on footrest type, loosen the screw using
either a 4mm allen wrench or an 11mm socket and set
the footrest at the height desired, then tighten the screw
in the hole.
Note: Make sure that the screws are tightened securely.
12.2 Inner Or Outer Width Adjustment of the footrests:
Using an optional kit the width between the footrests
can be made 4cm larger or smaller than standard. An
instruction sheet is included in the kit.
12.3 Adjustment of the armrests:
Height adjustment (Fig. 12.3):
Loosen cap screw (arrowed), lift armpad to desired height,
tighten cap screw to a torque of 3-7Nm.
12.4 Seat width adjustment (Fig. 12.4):
To adjust the width between the armrests, use a size 5mm
Fig. 12.1.1
allen wrench to loosen the cap screws on the armrest
adapter retainers, which are located on the side frame
below the armrests, and pull the armrests outwards or
inwards to achieve the desired position. Tighten screws to
a torque of 3-7Nm.
Fig. 12.1.2
Fig. 12.2
Fig. 12.3
Fig. 12.4
41
Rev. A Q100R Q200R