Table of Contents
Advertisement
H. DUAL POST HEIGHT ADJUSTABLE ARMREST
The dual post flip-back armrest can be used as either a
flip-back armrest or a removable armrest.
1. Installing armrest:
a) Insert front and rear posts (A) into
armrest receivers.
b) Engage lever (B) and insert the rear
safety pin (C).
2. Set-up for flip-back operation:
a) Disengage lever (B) to free front post (A).
b) Armrest now has the ability to be flipped
back without removal.
3. Set-up for removal:
a) Disengage levers (B) and pull out the rear safety
pin (C) to free both front and rear posts (A).
b) Armrest can now be easily removed for transferring.
4. Height adjustment:
a) Release the upper securing lever (D).
b) Set at desired height.
c)
Return securing lever to locked position.
d) Move armrest up or down to allow armrest to snap
into place.
D
A
C
B
22
I. CANTILEVER AND RECLINING ARMREST
(Fig.5)
ADJUSTMENT
(Fig.6-7)
Both the cantilever and reclining armrests are height
adjustable, but they are not removable.
1. Cantilever armrest adjustment:
(Fig.6)
a) To adjust, remove the two bolts (E) behind
the armrest with 2
" wrench.
7
/
16
b) Reposition in the available holes for
desired height.
c)
Retighten bolts (E) on each side.
2. Reclining armrest adjustment on seat frame:
a) To adjust, loosen screws (F) on the collar behind
the armrest with a
" Allen key and bolt (G)
3
/
16
from the vertical tube.
b) Reposition to the desired height.
c)
Tighten screws (F) on the collar behind the
armrest, and install and tighten bolt (G) on the
vertical tube.
d) To release the armrest, press the release lever (H)
towards the inside of the wheelchair, then lift.
!
WARNING
Reinstall bolts and tighten them securely.
5
G
H
IX
. OPERATING GUIDE
A. BATTERY CABLE AND FUSES
Your Quickie is equipped with two safety mechanisms which
uses a breaker and MIDI style fuses.
NOTE
- In the unlikely event of a short circuit or heavy overload, all
power to your wheelchair will be shut off. To reset your wheelchair,
press the breaker button. Should resetting the breaker not solve
the problem, you will need to replace the battery harness which
includes the fuses.
To reset the breaker and access the battery harness:
a) Squeeze tabs together to open the door.
(Fig.7)
b) Drop the panel down and pull out the batteries (A).
c)
Reset the breaker or replace the battery harness by
following the wiring instructions located inside the
battery access door.
d) Push the batteries back in the compartment.
e) Lock the panel back in its upright position and
make sure the tabs are secured on each side of the
battery compartment.
6
E
Repeated shutdown:
If the power wheelchair continues to pop the breaker
or blow the fuses, please have it serviced by your
authorized supplier.
7
F
B. JOYSTICK ASSEMBLY
The joystick connects to a power module, which controls
(Fig.1)
the power wheelchair's performance. The joystick varies
based on the option selected for you.
1. R-Net (option)
1
2. VR2 joystick
A
NOTE
- Please refer to the Owner's Manual provided
with informa tion package.
23
Advertisement
Table of Contents
