Optional Remote Installation - Lopi Northfield MV Owner's Manual

Optional Equipment

Optional Remote Installation

1 Locate the Green and White wires labeled "REMOTE" near the gas control valve.
2 Connect the Green and White wires from the back of the remote to the "REMOTE" wires found in step
1.
3 Remove clear plastic film from the Velcro strips on the bottom of the heatshield for the receiver. Turn
the assembly over so the strips are facing downward. Gently push the wires back into the appliance
as you move the receiver assembly into place. Adhere the assembly to the floor of the controls area
of the stove. Make sure the placement does not obstruct the movement of the door.
4 Check that wires are not making contact with any hot surfaces or moving parts (blower impellers if
installed). Adjust if necessary.
5 Install 4AA batteries into the receiver and 3AAA batteries into the transmitter.
6 Sync the transmitter with the receiver (see instructions included with the remote kit).
© Travis Industries
(for qualified installers only)
4/20/2018 - 1461
41
Northfield MV