Adjusting The Blower Speed (Optional); Normal Operating Sounds; Normal Operating Odors; Power Outages - Lopi Northfield MV Owner's Manual

Adjusting the Blower Speed (Optional)

The optional blower helps transfer heat from the heater into the room. It will not turn on until the heater is
up to temperature (approximately 10 minutes after starting). See the illustration below for instructions on
adjusting the blower speed.
OFF
Turn the dial all the
way counter-clockwise
until it clicks off.

Normal Operating Sounds

Extinction Pops
It is not unusual, especially on Propane
(LP) appliances, to experience a "pop"
when the burner is shut off.
Pilot Flame
The pilot flame will make a clicking
sound when starting up. When on, it
will make a slight whisper sound.
Gas Control Valve
As the gas control valve is turned on and off you will hear a dull
clicking sound. This is the valve opening up and shutting down.

Normal Operating Odors

This appliance has several areas that reach high temperatures. Dust or other particles on these areas
may burn and create an odor. This is normal during start-up. You may notice the smell is more acute if
the appliance was left idle for a long period.

Power Outages

The heater will work if household current (AC power) is disconnected.
© Travis Industries
Maintenance
HIGH
The high position is all the
way counter-clockwise,
without clicking off.
4/20/2018 - 1461
LOW
Turn the dial all the
way clockwise.
The appliance may creak with change
of temperature -- THIS IS NORMAL.
Blowers
This heater has optional blowers to push
heated air into the room. You will hear the
sound of air movement increase as the
speed is of the blower is increased.
Northfield MV
31