Accent Light; Adjusting The Optional Blower Speed; Continuous Pilot / Greensmart™ Pilot Switch35 - Lopi berkshire GS2 Owner's Manual

Hide thumbs Also See for berkshire GS2:
Table of Contents

Advertisement

Accent Light

This stove has a built-in accent light that
may be turned on and off and dimmed
to your preference. Turn the knob to
achieve the desired light output.

Adjusting the Optional Blower Speed

The blower helps transfer heat from the heater into the room. It will not turn on until the heater is up to
temperature (approximately 15 minutes after starting). See the illustration below for instructions on
adjusting the blower speed.
NOTE:
With the rear burner off (comfort control), the heater may not become hot enough for the
blower to turn on.
Continuous Pilot / GreenSmart™ Pilot Switch
This stove may run with the pilot continuously running or in GreenSmart
(intermittent) mode. For most homeowners, the GreenSmart mode is
preferred (this saves fuel, doesn't give off un-needed heat). However, in
some situations the homeowner may prefer to switch the stove to
continuous pilot. The most typical reasons for switching to continuous
pilot are:
Very Cold Conditions – in very cold conditions you may notice that the burner does not light quickly,
and the flames lift off the burner. If this is situation, we recommend you switch to continuous pilot.
This will create a slight draft in the vent, allowing for the burner to light quickly and draft correctly.
Excessive Condensation on Glass After Startup – certain installations may encounter excessive
fogging on the window after startup (not just the first time the stove was started). This is an aesthetic
condition that may be remedied by switching the stove to continuous pilot.
Cold Glass or Stove Front – in very cold conditions you may notice that the stove front and glass
become very cold. To remedy this, switch the stove to continuous pilot.
Frequent On / Off Operation – if you are frequently turning the stove on and off, you may wish to
leave it in continuous pilot. This allows the burner to turn on more quickly, without pilot ignition delay.
© Travis Industries
Operation
4141208
35
100-01399

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents