Related Manuals for Luxul AGS-1008M
Summary of Contents for Luxul AGS-1008M
-
Page 1: Quick Install Guide
QUICK INSTALL GUIDE 8-Port Gigabit Switch AGS-1008M Includes: AGS-1008M 8-Port Gigabit Switch „ Magnet Mount Kit „ Rubber Feet „ Power Cord „... -
Page 2: Setup And Configuration
Locate the small, circular magnets included in the AGS-1008M box. Place the magnets in the circular indentions located on the bottom of the AGS-1008M, lining up the screw-holes. Use the screws included in the AGS-1008M box to fasten the magnets to the device. Take care to not tighten the magnets too much as they may snap under excessive pressure. - Page 3 AGS-1008M to a surge protected outlet. CAUTION: Use only the included power supply. A different power supply could damage the AGS-1008M. To power the switch via PoE, connect the AGS-1008M to another switch via the PoE In port. PoE Powered...
-
Page 4: Connecting Devices
Connecting Devices Use an Ethernet cable to connect the AGS-1008M to a device as shown below. Luxul recommends at least Cat-5e unshielded twisted pair (CAT5e UTP) cabling. To ensure best performance and stable data transmission at 1000 Mbps, use Category-6 unshielded twisted pair (CAT6 UTP). -
Page 5: Connecting To A Router Or Other Switch
Connecting to a Router or Other Switch Use an Ethernet cable to connect the AGS-1008M to a router or other switch as shown below. The AGS-1008M automatically adjusts to the speed and duplex of the connected switch or router, so uplink cables are not necessary. -
Page 6: Hardware Operation
Hardware Operation The front panel of the AGS-1008M switch features one Power LED as well as a Link/Activity LED for each port. The back panel of the switch includes (16) 10/100/1000 Mbps RJ-45 ports, a power connector, and a switch to select blue or green front-panel LEDs. -
Page 7: Status Indicators
The following table describes front-panel LED functionality: Indicator State Description Power The AGS-1008M is switched on. AGS-1008M is switched off or not connected to AC power. Check power connections and power switch at on the rear of the unit. Link/Act Device connected to the port. Flashing Port is receiving or transmitting data. -
Page 8: Technical Support
Luxul product. © Copyright 2017 Luxul. All rights reserved. The name Luxul, the Luxul logo, the Luxul logo mark and Simply Connected are all trademarks and or registered trademarks of Luxul Wireless, Inc. All other trademarks and registered trademarks are property of their respective holders.
Need help?
Do you have a question about the AGS-1008M and is the answer not in the manual?
Questions and answers