Setting The Operating Program - Viessmann VITODENS Operating Instructions Manual

Operating program

Setting the operating program

Only necessary if "Only DHW"
is selected.
Tap the following on-screen buttons:
1. "Heating circuit 1 2 3" in the header to select the
required heating circuit
2.
or
The frame around the set operating program is
highlighted in white.
Time program
Further information can be found in chapter
"Terminology" in the appendix.
Setting a time program
Factory setting: One time phase from 6:00 to 22:00 h
for every day of the week
1. "Menu"
2. "Heating"
3. "Heating circuit 1", "Heating circuit 2" or "Heat-
ing circuit 3" as the required heating circuit
Heating curve
Further information can be found in chapter
"Terminology" in the appendix.
Setting the heating curve
Factory setting:
■ "Slope": 1.4
"Level": 0
■
Tap the following on-screen buttons:
1. "Menu"
2. "Heating"
(cont.)
or "Standby mode" 3. "Heating and DHW" to set central heating
4. OK to confirm
For information on the operating programs, see
page 13.
4. "Time program, heating"
For how to set a time program, see page 14.
Note
When adjusting the setting, bear in mind that your
heating system requires some time to heat the rooms
to the required temperature.
3. "Heating circuit 1", "Heating circuit 2" or "Heat-
ing circuit 3" as the required heating circuit
4. "Heating curve"
5. +/ for the required value for "Slope" or "Level"
–
6. OK to confirm
Central heating
25