Page 2
WiperLock, Wireless DNA, and ZENA are trademarks of Microchip Technology Incorporated in the U.S.A. and other countries. SQTP is a service mark of Microchip Technology Incorporated in Microchip received ISO/TS-16949:2009 certification for its worldwide headquarters, design and wafer fabrication facilities in Chandler and the U.S.A.
Customer Support • Document Revision History DOCUMENT LAYOUT This document describes how to use the MIC38300 Evaluation Board as a development tool to emulate and debug firmware on a target board. The manual layout is as follows: • Chapter 1. “Product Overview”...
Curly brackets and pipe Choice of mutually exclusive errorlevel {0|1} character: { | } arguments; an OR selection Ellipses... Replaces repeated text var_name [, var_name...] Represents code supplied by void main (void) user { ... 2018 Microchip Technology Inc. DS50002796A-page 5...
Preface RECOMMENDED READING This user’s guide describes how to use the MIC38300 Evaluation Board. Another useful document is listed below. The following Microchip document is available and recommended as a supplemental reference resource: ® MIC38300 Data Sheet – “HELDO 3A High-Efficiency Low Dropout Regulator”...
5 mV . All of these, combined with the optimized archi- pkpk tecture of the MIC38300 device that is targeting fast transient response, make this part ideal for powering ASICs, FPGAs or point of load applications. FIGURE 1-1: MIC38300 Evaluation Board –...
The MIC38300 Evaluation Board operates with an input supply voltage range of 3V up to 5.5V and has an adjustable output, which is set to 1.8V. The MIC38300 Evaluation Board comes with test points, allowing easy integration into a test set-up.
3V in order to test the 1.8V output voltage option (V + 1.2V). Do not apply a voltage higher than 5.5V, as the part can be damaged in the process. The MIC38300 device is on, as the default option; being turned on with a pull-up resistor to V , the part can be shut down by placing a jumper on the EN connector.
1.8V. 3. Connect an electronic load between V and GND set to maximum load current of 2.2A for the MIC38300 device. Resistors can also be used between the V and GND terminals as a load. Test V (should be 1.8V).
MIC38300 EVALUATION BOARD USER’S GUIDE Appendix A. Schematic and Layouts INTRODUCTION This appendix contains the following schematics and layouts for the MIC38300 Evaluation Board: • Board – Schematic • Board – Top Silk • Board – Top Copper and Silk •...
New York, NY Tel: 46-31-704-60-40 Tel: 631-435-6000 Sweden - Stockholm San Jose, CA Tel: 46-8-5090-4654 Tel: 408-735-9110 UK - Wokingham Tel: 408-436-4270 Tel: 44-118-921-5800 Canada - Toronto Fax: 44-118-921-5820 Tel: 905-695-1980 Fax: 905-695-2078 2018 Microchip Technology Inc. DS50002796A-page 18 08/15/18...
Need help?
Do you have a question about the MIC38300 and is the answer not in the manual?
Questions and answers