Page 2
® DSCs, K ® code hopping Germany II GmbH & Co. KG, a subsidiary of Microchip Technology devices, Serial EEPROMs, microperipherals, nonvolatile memory and Inc., in other countries. analog products. In addition, Microchip’s quality system for the design and manufacture of development systems is ISO 9001:2000 certified.
• Customer Support • Document Revision History DOCUMENT LAYOUT This document describes how to use the MIC4802 Evaluation Board as a development tool. The manual layout is as follows: • – Important information about the MIC4802 Chapter 1. “Product Overview”...
MIC4802 Evaluation Board User’s Guide CONVENTIONS USED IN THIS GUIDE This manual uses the following documentation conventions: DOCUMENTATION CONVENTIONS Description Represents Examples Arial font: ® Italic characters Referenced books MPLAB IDE User’s Guide Emphasized text ...is the only compiler... Initial caps...
Preface RECOMMENDED READING This user’s guide describes how to use the MIC4802 Evaluation Board. Other useful documents are listed below. The following Microchip document is available and recommended as a supplemental reference resource: • MIC4802 Data Sheet – “High Efficiency 800mA Single Channel Linear WLED Driver with Ultra Fast PWM™...
1.2.2 MIC4802 Device Overview The MIC4802 is a high efficiency White LED (WLED) linear driver designed to drive a single LED up to 800 mA. The MIC4802 provides the highest possible efficiency, as this architecture has no switching losses present in traditional charge pumps or inductive boost circuits.
MIC4802 EVALUATION BOARD DESCRIPTION The board is populated with the MIC4802YME device and uses a high power white LED as a load. The MIC4802 Evaluation Board has been developed to evaluate a typical application, where V is between 3.0V to 5.5V and current trough LED is fixed to 600 mA.
USER’S GUIDE Chapter 2. Installation and Operation INTRODUCTION MIC4802 is a high efficiency linear White LED driver designed to drive a single LED up to 800 mA. MIC4802 is a constant current driver designed to drive high power LEDs in various lighting applications.
PWM signal, as shown in the following scope shots. Pulling the EN low for more than 40 ms puts the MIC4802 into a low IQ sleep mode. The EN pin cannot be left floating because a floating enable pin may cause an indeterminate state on the outputs.
GND copper plane using a via under the device. As the MIC4802 has an exposed pad, the copper plane will help conduct the heat away from the device and improve thermal performance. Moreover, doing this will also help shield the device and improve output ripple performance.
MIC4802 EVALUATION BOARD USER’S GUIDE Appendix A. Schematic and Layouts INTRODUCTION This appendix contains the following schematics and layouts for the MIC4802 Evaluation Board: • Board – Schematic • Board – Top Silk Layer • Board – Top Copper and Silk Layer •...
New York, NY Tel: 46-31-704-60-40 Tel: 631-435-6000 Sweden - Stockholm San Jose, CA Tel: 46-8-5090-4654 Tel: 408-735-9110 UK - Wokingham Tel: 408-436-4270 Tel: 44-118-921-5800 Canada - Toronto Fax: 44-118-921-5820 Tel: 905-695-1980 Fax: 905-695-2078 2018 Microchip Technology Inc. DS-50002780A-page 27 10/25/17...
Need help?
Do you have a question about the MIC4802 and is the answer not in the manual?
Questions and answers