Table of Contents
Advertisement
2-15.
Front Lens Assembly
Preparation
1.
Remove the bottom panel assembly. (Refer to
2.
Remove the inside panel assembly. (Refer to
3.
Remove the outside panel assembly. (Refer to
4.
Remove the rear panel assembly. (Refer to
5.
Remove the handle assembly. (Refer to
6.
Remove the IO block. (Refer to
7.
Remove the DCP-64 board. (Refer to
Procedure
1.
Remove the four screws and pull out the front lens assembly in the direction of the arrow.
2.
Disconnect the harness from the connector on the CN-3634 board.
3.
Disconnect the harness from the connector on the AU-357 board.
Front lens assembly
Connector
(CN-3634 board)
P2.6 x 5
4.
Install the removed parts by reversing the steps of removal.
PMW-300
"2-5. Bottom Panel
"2-6-1. Inside Panel
"2-7-1. Outside Panel
"2-7-1. Outside Panel
"2-11-1. Handle
"2-10. IO
Block")
"2-14. DCP-64
Board")
Harness
P2.6 x 5
Assembly")
Assembly")
Assembly")
Assembly")
Assembly")
Connector
(AU-357 board)
Harness
2-47
Advertisement
Table of Contents
