Handle U-Case Assembly - Sony PMW-300 Service Manual

2-11-2.

Handle U-case Assembly

Preparation
1. Remove the bottom panel assembly. (Refer to
2. Remove the inside panel assembly. (Refer to
3. Remove the outside panel assembly. (Refer to
4. Remove the rear panel assembly. (Refer to
5. Remove the handle assembly. (Refer to
Procedure
1. Open the microphone holder assembly.
2. Remove the two screws (P2.6 x 5) to detach the microphone holder assembly.
3. Remove the five screws (P2 x 5) and lift up the handle U-case assembly.
4. Disconnect the flexible board from the connector (CN101) on the HN-411 board and detach the handle U-case
assembly.
P2.6 x 5
Flexible board
CN101
HN-411 board
5. Install the removed parts by reversing the steps of removal.
PMW-300
"2-5. Bottom Panel Assembly")
"2-6-1. Inside Panel Assembly")
"2-7-1. Outside Panel
"2-8. Rear Panel Assembly")
"2-11-1. Handle Assembly")
Microphone holder assembly
P2 x 5
Handle U-case assembly
Assembly")
P2 x 5
2-35