2-9.
SxS Block
2-9-1.
SxS Slot Assembly
Preparation
1.
Remove the bottom panel assembly. (Refer to
2.
Remove the inside panel assembly. (Refer to
Procedure
1.
Disconnect the flexible flat cable from the connector on the SWC-56 board.
2.
Disconnect the two fine-wire coaxial cables from the connector on the SWC-56 board and the connector on the
EC-78 board.
3.
Disconnect the harness from the connector on the IF-1244 board.
4.
Remove the four screws to detach the SxS slot assembly.
Connector
Connector
(IF board)
Flexible flat cable
Note
When reconnecting the fine-wire coaxial cables, connect correct connectors.
5.
Install the removed parts by reversing the steps of removal.
PMW-300
"2-5. Bottom Panel
"2-6-1. Inside Panel
Precision screws
(P2 x 4)
Harness
SWC board
Mark
Fine-wire coaxial cables
Assembly")
Assembly")
Connector
SxS slot assembly
Connector
(EC board)
2-28