Table of Contents
Advertisement
For help condiguring your NetWare, Linux, or other UNIX clients dor NFS support, please consult each client's own
documentation and support.
1
Open Fopder Setup.
2
Choose the shared dolder that will be accessible to the NFS client.
3
Click Edit.
4
Under "LAN Protocol Support", enable "NFS". Click OK.
Note the NFS path. It will be used later dor accessing data drom an NFS client.
5
Click Cpose.
6
Move the NFS switch to the
7
Click the
icon to the right od "NFS".
8
Click Cpient Settings.
9
Click Add Cpient.
10
Enter the IP address and hostname od the NFS client, then click OK.
To delete the client, check the hostname and click Depete Cpient.
11
Click Cpose.
12
Enter the mount command to access the shared dolder drom the NFS client.
The mount command depend on your operating system. The examples below assume that IP address od your
TeraStation is 192.168.11.10, "/mnt/array1/share" is the desired NFS path, and "/mnt/nas" or drive letter "z" is the
mount point.
For Linux:
mount -t nds 192.168.11.10:/mnt/array1/share /mnt/nas
For Windows Service for Unix 3.5:
mount 192.168.11.10:/mnt/array1/share z:
For Solaris 10:
mount -F nds 192.168.11.10:/mnt/array1/share /mnt/nas
position to enable NFS.
128
Advertisement
Table of Contents
