Problem At Starting Os - NEC Express5800/E120g-M Maintenance Manual

Chapter 1 Maintenance
[?] Unable to start from the OS installation media of Windows Server 2008 R2
 Is x2APIC feature of the processor disabled?
→ Disable X2APIC feature of the processor in BIOS Setup Utility.
Advanced → Processor Configuration → X2APIC → Disabled
[?] The screen turns black or the stop error (0x0000005C) appears while installing Windows Server 2008 R2
 Is X2APIC feature of the processor disabled?
→ Disable X2APIC feature of the processor in BIOS Setup Utility.
Advanced → Processor Configuration → X2APIC → Disabled
5.4

Problem at Starting OS

[?] Unable to start OS
 Have the settings of the RAID controller changed?
→
Specify the correct settings with RAID Configuration Utility (LSI Software RAID Configraition Utility or
Off-line Utility).
 Is the RAID controller found by POST?
→ Be sure to connect the RAID controller correctly and retry.
 Is the RAID controller installed firmly straight into the PCI slot?
→
Install the RAID controller properly.
 Is the RAID controller mounted on the PCI slot for which the mounting is restricted?
→
Check the mounting restrictions of the server and then mount the RAID controller on the correct slot.
 Are the hard disk drives properly installed?
→ Install the hard disk drives properly.
 Is the SAS cable connected to the hard disk drive correctly?
→
Connect the SAS cable properly.
 Is the EXPRESSBUILDER DVD inserted?
→
Remove the EXPRESSBUILDER DVD and restart.
 Is a cartridge inserted into N8151-105/125 built-in RDX (USB)?
→
Either remove the cartridge or change the boot order in BIOS Setup Utility.
 Is a disk array unit connected to the PCI card?
→ Change the boot order from BBS Priorities in BIOS Setup Utility.
Express5800/E120g-M Maintenance Guide
5. Troubleshooting
31