NEC Express5800/E120g-M Maintenance Manual page 65

Chapter 2 Useful Features
(a) PCI Device Controller and Option ROM Settings submenu
The following screen appears when UEFI is selected for Boot Mode in Boot menu.
On this menu, you cannot select VGA Priority option. If you want to specify VGA Priority, change Boot Mode
to Legacy in Boot menu.
For details about the options, see the table below.
VGA Controller
VGA Priority
LAN Controller
LAN1 Option ROM Scan
LAN2 Option ROM Scan
LAN3 Option ROM Scan
LAN4 Option ROM Scan
PCI1 Slot Option ROM
PCI2 Slot Option ROM
Option
Disabled
[Enabled]
[Onboard]
Offboard
Disabled
[Enabled]
Disabled
[Enabled]
Disabled
[Enabled]
Disabled
[Enabled]
Disabled
[Enabled]
Disabled
[Enabled]
[Disabled]
Enabled
Note
For a RAID Controller, LAN card (network boot), or Fibre Channel controller, if no
Hard Disk Drive on which an OS is installed is connected, set the option ROM for
that slot to Disabled.
Express5800/E120g-M Maintenance Guide
Parameter
Enable or disable the onboard VGA controller.
This option is automatically set to Enabled if
only the onboard VGA controller is valid and
Serial Redirection is disabled.
Specify priority to expand ROM of VGA
controller..
Enable or disable the onboard LAN controller.
This option is fixed to Enabled if Shared LAN
is enabled in Off-line Tools.
Enable or disable the option ROM SCAN for
onboard LAN 1.
Enable or disable the option ROM SCAN for
onboard LAN 2.
Enable or disable the option ROM SCAN for
onboard LAN 3.
Enable or disable the option ROM SCAN for
onboard LAN 4.
Enable or disable the option ROM on PCI slot.
1.
Enable or disable the option ROM on PCI slot.
2.
1. System BIOS
Descriptions
[ ]: Factory setting
65