3.2.1 Configure Switch
1 Make sure that the link between Switch-2 and Switch-3 is not
connected to prevent unintended loops before finishing the
RSTP setup.
2 Set up Switch-1: Enter the web GUI. Go to Menu > Advanced
Application > Spanning Tree Protocol > Configuration. Check
if the Spanning Tree Configuration is Rapid Spanning Tree. If
not, select it and click "Apply".
3 Set up Switch-1: Enter the web GUI. Go to Menu > Advanced
Application > Spanning Tree Protocol > RSTP. Check the
"Active" box. Set the Bridge Priority = 4096. Active port 1, 2.
Click "Apply".
www.zyxel.com
99/215