Detaching And Refitting The Fuser Heater Lamp M And S - Kyocera FS-6970DN Service Manual

(2) Detaching and refitting the fuser heater lamp M and S

Procedure
1. Remove the fuser unit (See page P.1-5-16).
2. Remove two screws and then open the
fuser unit.
NOTE:
When fixing the screw again, be careful not
to tighten the screw too much because the
fuser lower frame is made of resin.
3. Remove two screws from the fuser heater
lamp M and S.
Screw
Fuser unit
Fuser heater lamp M
Fuser heater lamp S
Screw
Figure 1-5-23
Figure 1-5-24
2J5
Screw
Screw
Nut
Nut
1-5-17