Kyocera FS-6970DN Service Manual page 74

2J5
4. Remove two screws from the fuser heater
lamp M and S.
5. Remove the fuser heater lamp M and S.
6. Check or replace the fuser heater lamp M
and S, and refit all the removed parts.
Seat the fuser heater lamp M and S aligning
its wattage mark and welding mark faced
with the correct direction and side.
1-5-18
Screw
Screw
Terminal
Terminal
Nut
Nut
Fuser heater lamp M
Rating mark
Welding side
Screw
Screw
Welding side
Fuser heater lamp M
Fuser heater
lamp S
Rating mark
Figure 1-5-25
Fuser heater
lamp S