Kyocera FS-6970DN Service Manual page 82

2J5
20. Remove the connector.
21. Remove two screws-A and then remove the
HV plate.
22. Remove two screws-B and then remove the
engine R ground plate, engine L ground
plate and shield plate.
23. Check or replace the engine PWB and refit
all the removed parts.
To replace the engine PWB, remove the
EEPROM from the old engine PWB and
mount it to the new engine PWB.
1-5-26
EEPROM
HV plate
Screw-A
Screw-A
Connector
Engine PWB
Screw-B
Engine R
grounding plate
Shield plate
Engine L
grounding plate
Figure 1-5-38
Screw-B