Kyocera FS-6970DN Service Manual page 96

2J5
11. Confirm that the printer's power switch is set
to off.
12. Insert the memory card into the printer's
memory card slot.
13. Turn printer power on.
14. When message display (1) is displayed to
detect firmware in the memory card.
15. Message display (2) is displayed during
downloading.
16. When message display (3) is displayed to
indicate downloading is finished.
17. Turn printer power off.
18. Remove the memory card from memory
card slot.
19. Refit the option interface slot cover by two
screws.
20. Turn printer power on.
21. Confirm that message display (4) is dis-
played after warm-up.
22. Print the status page. Print the status page
to check that the firmware version has been
updated.
1-6-4
Memory card slot
Figure 1-6-7
Power switch: On
Supervisor mode
(1)
Supervisor mode
(2)
USB data reading
2J5_3000.001.021
(3)
[E1F9]
Power switch: Off
Memory
card slot
Power switch: On
(4)
Ready
Figure 1-6-8
Memory card
Message display
Product code
2J5: This machine
Firmware category
10: Engine
30: System (Main)
31: System (BROM)
Supplement
(Normally: 00)
Classification
(Normally: 0)
Update history
Build number
Checksum
Memory
card