Removing An Interface Submodule From The Card Slot Of An Expansion Module - Siemens S7-400 Installation Manual

Assembling the M7-400
Warning
!
The interface submodules can be damaged.
If you replace two or more interface submodules simultaneously and interchange
their front connectors, the interface submodules can be damaged.
Mark the front connectors so that they are assigned to the corresponding interface
submodules.
Frame of card slot with
mounting hole
Figure 8-21
Fitting an Interface Submodule
Fit the new interface submodule in the reverse order. Further information can be
found in Section 8.4.4, "Installing Interface Submodules" from page 8-13.
8-48
EXM 478
Removing an Interface Submodule from the Card Slot of an Expansion
Module
S7-400 and M7-400 Programmable Controllers Hardware and Installation
Guides
A5E00069481-04