Table 6-2
do not use battery monitoring,
use battery monitoring with a single-width
power supply module,
want to monitor a backup battery with a
double or triple-width power supply module,
want to monitor two backup batteries with a
double or triple-width power supply module,
6.3
Connecting a Programming Device (PG) to an S7-400
Connecting a Programming Device (PG) to an S7-400
You must connect the programming device via a connecting cable to the MPI of the
CPU. This allows access via the communication bus to all CPUs and
programmable modules.
Figure 6-1 Connecting PG to an S7-400
Note
The programming device is not ungrounded. To operate the S7-400 in an
ungrounded configuration, you must connect the programming device via an
RS 485 repeater (see Reference Manual Module Specifications, Chapter 10).
S7-400 and M7-400 Programmable Controllers Hardware and Installation
A5E00069481-04
Setting the Battery Monitoring Switch
If You ...
S7-400
PG cable
...Then
set the BATT INDIC switch to OFF.
set the BATT INDIC switch to BATT.
set the BATT INDIC switch to 1BATT.
set the BATT INDIC switch to 2BATT.
Programming device
Starting Up
6-5