Siemens S7-400 Installation Manual page 311

Index
A
Accessories, 2-39
Addresses
geographical, 3-2
logical, 3-2
Addressing modules, M7-400, 8-5
Analog modules, replacing, 7-7
Assembling the bus cable, on a bus connector
with order number 6ES7 ..., 5-20
Assembling, M7-400
MPI subnet, 8-30
PROFIBUS-DP subnet, 8-30
Assembly
central, 2-2
distributed, 2-2
Assembly, M7-400
interface submodules, 6-18, 8-13
module accessories, 8-10
AT card, M7-400, fitting, 8-56
ATM 478, M7-400
fitting the short AT card, 8-15
replacing a short AT card, 8-56
B
Backup battery
disposing, 7-3
inserting, 6-13
removing, 7-2
replacing, 7-2
using, 7-3
Baud Rate, 5-3
Bus cable, length of spur lines, 5-16
Bus connector
connecting to the module, 5-22
purpose, 5-19
removing, 5-22
setting the terminating resistor, 5-22
terminating resistor, 5-9
Bus connectors, assembling bus cables, 5-20
Bus segment. See Segment
S7-400 and M7-400 Programmable Controllers Hardware and Installation
A5E00069481-04
C
C bus, 2-7
Cable lengths, maximum, 5-15
Cabling, inside buildings, A-17
Changing fuse, digital modules, 7-9
Channel
on a digital module, 3-6
on an analog module, 3-7
Checklist, M7-400
installation, 8-9
preparing for operation, 8-32
Choosing the Power Supply Module, M7-400,
8-6
COM interface, M7-400, connecting a
PC/programming device, 8-36
Commissioning, M7-400
checklist, 8-9
sections, 8-32
Communication, programming device – CPU,
6-6
Communication bus (C-bus), 2-7
Components
for MPI network, 5-8
of the S7-400, 1-1
PROFIBUS-DP network, 5-8
Configuration
electrical, A-2
interference-free, 4-15
Connecting a mouse, M7-400, 8-35
Connecting a programming device, 6-5
Connecting terminal, M7-400, 8-22
Connecting, M7-400
module assembly, 8-29
operator panels and I/O devices, 8-33
PC, 8-36
programming device, 8-36
Connection, rules, 2-5
Connection, M7-400
keyboard, 8-33
VGA monitor, 8-33
Connector, M7-400, removing the cover, 8-18
Index-1