Putting Into Operation; Switching The Appliance On And Off; Other Settings Installer - Brink Elan 16 2.0 Installation Instructions Manual

7.1 Switching the appliance on and off

Switching on:
Switching on the mains power;
Connect the 230 V power plug to the electric system.
All display symbols appear during 2 seconds.
The hardware code appears during 2 seconds.
Then the software version appears during 4 seconds.
Subsequently, the Elan appliance is in operating mode and
goes to the preset value of the output temperature set at
step number 1.
Ex factory, the air quantities of the Elan appliance for the mini-
are set at respectively 20%, 65% and 80%.
The performance and the energy consumption of the Elan ap-
pliance depend on the pressure drop in the ducts system, as

7.3 Other settings installer

More settings of the Elan appliance can be changed. How to
modify these is explained in §6.3.
20
2 sec.
2 sec.
4 sec.
Elan 10 2.0 / Elan 16 2.0 / Elan 25 2.1 Revision D
Switching off:
Switching off the mains power;
Pull the 230 V mains plug from the mains to take the voltage
from the appliance.
Nothing is shown on the display now.
Warning
When working on the appliance, always take
it off through software and subsequently pulling
the power plug.