Cooling - Brink Elan 16 2.0 Installation Instructions Manual

appliance.
ance, it is assumed that the fronts of both appliances are kept
The connection "to dwelling" is connected at the top on the
5.9 Filter connection top / bottom
placed.
long countersunk Torx screws that hold the top panel.
2 Remove the top panel (it will be used later to replace the

5.10 Cooling

An Elan appliance can be equipped for cooling. For that purpo-
se an Elan cooling block (cooling block water or cooling block
a condensing unit must be connected to the cooling block. In
addition, a relay (mounted in the interface cooling that comes
the Elan on connection 7 and 8 on the 9-pole connector. (also
-
2 x 2 x
Torx T20 Torx T20
Elan 10 2.0 / Elan 16 2.0 / Elan 25 2.1 Revision D
Use the optionally available coupling kit (Brink article code
Renovent Elan.
If a Renovent Excellent is placed separately in the installation
room, this coupling it is not necessary and the air supply con-
nection of the Renovent Excellent can be connected to the re-
turn duct of the Elan air heater.
long Torx screws.
panel, see §5.7.
When cooling is switched on, the system will always be running
ling, a connection must be made between terminals 1 and 2 on
filter
unit
-
-
13