Water Connections; Connecting Ducts - Brink Elan 16 2.0 Installation Instructions Manual

with the doors and take out this panel so the control panel
with the mounting bracket is accessible.
panel to the front panel and rotate this control panel 180
degrees.

5.5 Water connections

The heat exchanger in the air heater is connected with 22 mm
It is recommended to place stop cocks with couplings directly
on the outside of the appliance in the input as well as the input
lines.
Use one of the breakout tabs for feeding through the water li-
nes. The water connections can be routed out of the appliance
on the left or on the right.

5.6 Connecting ducts

Standard manifolds are available for the Elan series.
ducts are connected to this manifold.
Observe the following items when connecting the ducts.
manifold or the main duct.
exterior air duct.
.
4x Torx T20
2x Torx T20
on the appliance and for a
under the appliance. The hot air
Elan 10 2.0 / Elan 16 2.0 / Elan 25 2.1 Revision D
Ø 22 mm when making the water connections.
an
app iance
prevent condensation.
not become sound bridges, so no straight connections bet-
ween two rooms.
Connect the return duct to the return air or the installation
room. An acoustic return plate is available for an appliance
with open return.
connect it to the return duct.
upport us
Water connection
11