Switch Off Timer; Factory Settings; Reinstall Your Television - Bang & Olufsen BeoVision Avant-55 User Manual

Switch Off Timer

In the Switch Off Timer menu, you can set the television to switch off automatically after
some time without operation. The factory setting is 4 hours. This function only applies in
video mode, not in audio mode.

Settings  
General settings  
Switch Off Timer  
...
When Switch Off Timer is activated, a message appears on your TV screen if the
television has not been operated during the time set in the menu. The television then
switches to standby if you do not operate it.
When no source signal has been detected for 10 minutes, the television may switch to
standby.

Factory settings

Reset picture and sound settings to default settings.

Settings  
General settings  
Factory settings  
...

Reinstall your television

To reinstall your television, follow on-screen instructions. After a reinstallation of your
television, it starts up in first-time setup. If you, for some reason, need to change country
setting in the television, you must reinstall your television and go through first-time setup
again.
Important! If you reinstall your television, the content on a connected hard disk drive
will no longer be accessible.

Settings  
General settings  
Reinstall TV  
...
50