Transport Of A Stand - Bang & Olufsen BeoVision Avant-55 User Manual

find 'Placement'.
Depending on your setup, you can bring up a Stand adjustment menu for stand positions
or wall bracket positions.
The calibration process allows you to set the maximum angle the television will turn – left
and right.
Set up the television with a motorised floor stand
1. In the Stand adjustment menu, use  and  to turn the television by the pipe of
the floor stand and  and  to turn the television by the base of the floor
stand. The television must be parallel to the wall behind.
2. Press the centre button to proceed to the next step.
3. Use ,  or the number buttons to enter the distance between the stand and
the wall.
4. Highlight Save and press the centre button.
If your television has just been moved, you will also be asked to set up new stand
positions. Press the red button in the on-screen help and find
more information.
Set up the television with a motorised wall bracket
1. In the Stand adjustment menu, press  or  to turn the television to the
preferred position when fully closed.
2. Press the centre button to proceed to the next step.
3. Press  or  to turn the television to the preferred position when fully opened.
4. Press the centre button to save.
Set up the television with a table stand
When mounted on a table stand, you can tilt the television to the position you prefer.
1. In the Stand adjustment menu, press  or  to tilt the television to a
preferred position.
2. Press the centre button to save.

Transport of a stand

Moving of your television and floor stand to a different location, must be done by
qualified personnel. You must activate the transport mode. This ensures that the
calibration menu is shown when you switch on the television again, so you can determine
the distance to the wall again. All the saved stand positions are deleted when you
activate transport mode.
WARNING! Do not lift or otherwise move your television physically when it is mounted
on the floor stand. It could cause the TV screen to break. Contact your retailer.
1. In the Stand transport menu, select Yes and press the centre button to activate
transport mode. To deactivate transport mode, select No instead.
When the stand has been moved, you must calibrate the stand and set up stand
positions again.
'Set a stand position' for
24